27
View
VLAN view
Default level
2: System level
Parameters
interval: Specifies an aging timer for dynamic router ports in seconds. The value ranges from 1 to 1000.
Description
Use igmp-snooping router-aging-time to configure the aging timer for dynamic router ports for a VLAN.
Use undo igmp-snooping router-aging-time to restore the default.
By default, the aging timer of a dynamic router port is 105 seconds.
This command takes effect only if IGMP snooping is enabled in the VLAN.
Related commands: igmp-snooping enable and router-aging-time.
Examples
# Enable IGMP snooping and set the aging timer for dynamic router ports to 100 seconds in VLAN 2.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping router-aging-time 100
igmp-snooping router-port-deny
Syntax
igmp-snooping router-port-deny [ vlan vlan-list ]
undo igmp-snooping router-port-deny [ vlan vlan-list ]
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view, port group view
Default level
2: System level
Parameters
vlan vlan-list: Specifies one or multiple VLANs. You can provide up to 10 VLAN lists. For each list, you
can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to
end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The value range of a VLAN
ID is 1 to 4094.
Description
Use igmp-snooping router-port-deny to disable a port from becoming a dynamic router port.
Use undo igmp-snooping router-port-deny to restore the default.
By default, a port can become a dynamic router port.
To Next Page
Loading...
Need help?
General