271
Related commands: group-policy.
Examples
# Apply ACL 2000 as an IPv6 multicast group filter so that hosts on Ethernet 1/0/1 in VLAN 2 can join
FF03::101 only.
<Sysname> system-view
[Sysname] acl ipv6 number 2000
[Sysname-acl6-basic-2000] rule permit source ff03::101 16
[Sysname-acl6-basic-2000] quit
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] mld-snooping group-policy 2000 vlan 2
mld-snooping host-aging-time
Syntax
mld-snooping host-aging-time interval
undo mld-snooping host-aging-time
View
VLAN view
Default level
2: System level
Parameters
interval: Specifies an aging timer for dynamic member ports in seconds. The value range is 200 to 1000.
Description
Use mld-snooping host-aging-time to set the aging timer for the dynamic member ports for a VLAN.
Use undo mld-snooping host-aging-time to restore the default.
By default, the aging timer of a dynamic member port is 260 seconds.
This command takes effect only if MLD snooping is enabled for the VLAN.
Related commands: display mld-snooping host, host-aging-time and mld-snooping enable.
Examples
# Enable MLD snooping and set the aging timer for dynamic member ports to 300 seconds in VLAN 2.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping host-aging-time 300
mld-snooping host-join
Syntax
mld-snooping host-join ipv6-group-address [ source-ip ipv6-source-address ] vlan vlan-id
To Next Page
Loading...
Need help?
General