308
View
System view
Default level
2: System level
Parameters
limit: Specifies the maximum number of entries in the IPv6 multicast forwarding table. The value ranges
from 0 to 1000.
Description
Use multicast ipv6 forwarding-table route-limit to configure the maximum number of entries in the IPv6
multicast forwarding table.
Use undo multicast ipv6 forwarding-table route-limit to restore the default.
By default, the upper limit is 1000.
Related commands: display multicast ipv6 forwarding-table.
Examples
# Set the maximum number of entries in the IPv6 multicast forwarding table to 200.
<Sysname> system-view
[Sysname] multicast ipv6 forwarding-table route-limit 200
multicast ipv6 load-splitting
Syntax
multicast ipv6 load-splitting {source | source-group }
undo multicast ipv6 load-splitting
View
System view
Default level
2: System level
Parameters
source: Specifies IPv6 multicast load splitting on a per-source basis.
source-group: Specifies IPv6 multicast load splitting on a per-source and per-group basis.
Description
Use multicast ipv6 load-splitting to enable load splitting of IPv6 multicast traffic.
Use undo multicast ipv6 load-splitting to disable load splitting of IPv6 multicast traffic.
By default, load splitting of IPv6 multicast traffic is disabled.
This command does not take effect in IPv6 BIDIR-PIM.
Examples
# Enable load splitting of IPv6 multicast traffic on a per-source basis.
<Sysname> system-view
[Sysname] multicast ipv6 load-splitting source
To Next Page
Loading...
Need help?
General