162
Parameters
interval: Hello interval in seconds, with an effective range of 1 to 2,147,483,647.
Description
Use pim timer hello to configure the interval at which hello messages are sent on the current interface.
Use undo pim timer hello to restore the default.
By default, hello messages are sent at the interval of 30 seconds.
Related commands: timer hello.
Examples
# Set the hello interval to 40 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim timer hello 40
pim timer join-prune
Syntax
pim timer join-prune interval
undo pim timer join-prune
View
Interface view
Default level
2: System level
Parameters
interval: Join/prune interval in seconds, with an effective range of 1 to 2,147,483,647.
Description
Use pim timer join-prune to configure the interval at which join/prune messages are sent on the current
interface.
Use undo pim timer join-prune to restore the default.
By default, the join/prune interval is 60 seconds.
Related commands: timer join-prune.
Examples
# Set the join/prune interval to 80 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim timer join-prune 80
pim triggered-hello-delay
Syntax
pim triggered-hello-delay interval
To Next Page
Loading...
Need help?
General