278
mld-snooping report source-ip
Syntax
mld-snooping report source-ip { ipv6-address | current-interface }
undo mld-snooping report source-ip
View
VLAN view
Default level
2: System level
Parameters
ipv6-address: Specifies a source IPv6 address for the MLD reports that the MLD snooping proxy sends,
which can be any legal IPv6 link-local address.
current-interface: Specifies the IPv6 link-local address of the current VLAN interface as the source
address of MLD reports that the MLD snooping proxy sends. If no IPv6 address has been assigned to the
current interface, the default IPv6 address FE80::02FF:FFFF:FE00:0001 is used.
Description
Use mld-snooping report source-ip to configure the source IPv6 address of the MLD reports that the MLD
snooping proxy sends.
Use undo mld-snooping report source-ip to restore the default.
By default, the source IPv6 address of the MLD reports that the MLD snooping proxy sends is
FE80::02FF:FFFF:FE00:0001.
Before you configure this command in a VLAN, enable MLD snooping for the VLAN.
The source IPv6 address configured in the mld-snooping report source-ip command also applies when
the simulated host sends MLD reports.
Related commands: mld-snooping enable.
Examples
# Enable MLD snooping in VLAN 2 and configure the source IPv6 address of MLD reports that the MLD
snooping proxy sends in VLAN 2 to FE80:0:0:1::1.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping report source-ip fe80:0:0:1::1
mld-snooping router-aging-time
Syntax
mld-snooping router-aging-time interval
undo mld-snooping router-aging-time
To Next Page
Loading...
Need help?
General