446
View
IPv6 MBGP address family view
Default level
2: System level
Parameters
ipv6-group-name: Specifies an IPv6 MBGP peer group by its name, a string of 1 to 47 characters.
ipv6-address: IPv6 address of an IPv6 MBGP peer.
Description
Use peer keep-all-routes to save the original routing information from an IPv6 MBGP peer or peer group,
including the routes that fail to pass the inbound filtering policy (if configured).
Use undo peer keep-all-routes to disable this function.
By default, the original routing information from an IPv6 MBGP peer or peer group is not saved.
Examples
# Save the original routing information from IPv6 MBGP peer 1:2::3:4.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1:2::3:4 as-number 100
[Sysname-bgp-af-ipv6] quit
[Sysname-bgp] ipv6-family multicast
[Sysname-bgp-af-ipv6-mul] peer 1:2::3:4 enable
[Sysname-bgp-af-ipv6-mul] peer 1:2::3:4 keep-all-routes
peer next-hop-local (IPv6 MBGP address family view)
Syntax
peer { ipv6-group-name | ipv6-address } next-hop-local
undo peer { ipv6-group-name | ipv6-address } next-hop-local
View
IPv6 MBGP address family view
Default level
2: System level
Parameters
ipv6-group-name: Specifies an IPv6 MBGP peer group by its name, a string of 1 to 47 characters.
ipv6-address: Specifies an IPv6 MBGP peer by its IP address.
Description
Use peer next-hop-local to configure the next hop of routes advertised to an IPv6 MBGP peer or a peer
group as the local router.
Use undo peer next-hop-local to restore the default.
To Next Page
Loading...
Need help?
General