450
ipv6-address: Specifies an IPv6 MBGP peer by its IP address.
limit: Specifies the upper limit of IPv6 address prefixes that can be received from the peer or peer group,
in the range of 1 to 6144.
percentage: Percentage at which the system will generate alarm information if the number of received
routes divided by the upper limit reaches it. The percentage is in the range of 1 to 100. The default is 75.
Description
Use peer route-limit to set the maximum number of IPv6 prefixes that can be received from an IPv6 MBGP
peer or a peer group.
Use undo peer route-limit to restore the default.
By default, the IPv6 prefixes from an IPv6 MBGP peer or a peer group are unlimited.
The router removes the TCP connection when the number of IPv6 prefixes received from the peer exceeds
the limit.
Examples
# Set the number of IPv6 address prefixes allowed to be received from the IPv6 MBGP peer 1:2::3:4 to
5000.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1:2::3:4 as-number 100
[Sysname-bgp-af-ipv6] quit
[Sysname-bgp] ipv6-family multicast
[Sysname-bgp-af-ipv6-mul] peer 1:2::3:4 enable
[Sysname-bgp-af-ipv6-mul] peer 1:2::3:4 route-limit 5000
peer route-policy (IPv6 MBGP address family view)
Syntax
peer { ipv6-group-name | ipv6-address } route-policy route-policy-name { import | export }
undo peer { ipv6-group-name | ipv6-address } route-policy route-policy-name { import | export }
View
IPv6 MBGP address family view
Default level
2: System level
Parameters
ipv6-group-name: Specifies an IPv6 MBGP peer group by its name, a string of 1 to 47 characters.
ipv6-address: Specifies an IPv6 MBGP peer by its IP address.
route-policy-name: Specifies a routing policy name, a case-sensitive string of 1 to 63 characters.
import: Applies the routing policy to routes received from the IPv6 MBGP peer or the peer group.
export: Applies the routing policy to routes advertised to the IPv6 MBGP peer or the peer group.
To Next Page
Loading...
Need help?
General