191
• If the cipher keyword is specified, the ciphertext password comprises 1 to 137 characters.
Description
Use peer password to configure an MD5 authentication password for the TCP connection to be
established with an MSDP peer.
Use undo peer password to restore the default.
By default, no MD5 authentication is performed for TCP connections to be established between MSDP
peers.
The MSDP peers involved in the MD5 authentication must have the same authentication method and
password. Otherwise, the authentication fails and the TCP connection cannot be established.
The plaintext password or ciphertext password is saved in cipher text in the configuration file.
Examples
# On the public network, configure the MD5 authentication password to aabbcc in plain text for TCP
connections to be established with M S D P p e e r 10 .1.10 0 .1. T h e c o n f i g u r ation on the peer is similar.
<Sysname> system-view
[Sysname] msdp
[Sysname-msdp] peer 10.1.100.1 password simple aabbcc
# In VPN instance mvpn, configure the MD5 authentication password to aabbcc in plain text for TCP
connections to be established with M S D P p e e r 10 .1.10 0 .1. T h e c o n f i g u r ation on the peer is similar.
<Sysname> system-view
[Sysname] msdp vpn-instance mvpn
[Sysname-msdp-mvpn] peer 10.1.100.1 password simple aabbcc
peer request-sa-enable
Syntax
peer peer-address request-sa-enable
undo peer peer-address request-sa-enable
View
Public network MSDP view, VPN instance MSDP view
Default level
2: System level
Parameters
peer-address: Specifies an MSDP peer address.
Description
Use peer request-sa-enable to enable the device to send an SA request message to the specified MSDP
peer after receiving a new join message.
Use undo peer request-sa-enable to disable the device from sending an SA request message to the
specified MSDP peer.
By default, after receiving a new join message, the router does not send an SA request message to any
MSDP peer. Instead, it waits for the next SA message to come.
To Next Page
Loading...
Need help?
General