431
display ipv6 multicast routing-table
Syntax
display ipv6 multicast routing-table [ verbose ] [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: M o n i t o r l e v e l
Parameters
verbose: Displays detailed routing table information, including both active and inactive routes. With this
argument absent, the command displays brief information about active IPv6 MBGP routes only.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use display ipv6 multicast routing-table to display the IPv6 MBGP routing table.
Active and inactive routes might coexist in the IPv6 MBGP routing table. Active routes are the optimal
routes used for RPF check.
Examples
# Display brief IPv6 MBGP routing table information.
<Sysname> display ipv6 multicast routing-table
Routing Table :
Destinations : 4 Routes : 4
Destination: 100::1/128 Protocol : Direct
NextHop : ::1 Preference: 0
Interface : InLoop0 Cost : 0
Table 98 Command output
Field Descri
tion
Destination Destination IPv6 address
Protocol Routing protocol
Nexthop Next hop IP address
Preference Route preference
Interface Outbound interface
Cost Route cost
To Next Page
Loading...
Need help?
General