435
Parameters
acl6-number: Specifies the number of a basic or advanced IPv6 ACL used to match against the
destination of routing information. The number is in the range of 2000 to 3999.
ipv6-prefix-name: Specifies the name of an IPv6 prefix list used to match against the destination of
routing information. The name is a string of 1 to 19 characters.
Description
Use filter-policy import to configure the filtering of inbound routing information using a specified filter.
Use undo filter-policy import to cancel the filtering of inbound routing information.
By default, inbound IPv6 MBGP routes are not filtered.
Examples
# Reference IPv6 ACL 2000 to filter all inbound IPv6 MBGP routes.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family multicast
[Sysname-bgp-af-ipv6-mul] filter-policy 2000 import
import-route (IPv6 MBGP address family view)
Syntax
import-route protocol [ process-id [ med med-value | route-policy route-policy-name ] * ]
undo import-route protocol [ process-id ]
View
IPv6 MBGP address family view
Default level
2: System level
Parameters
protocol: Redistributes routes from the protocol, which can be direct, isisv6, ospfv3, ripng or static at
present.
process-id: Specifies a process ID, in the range of 1 to 65535. This argument is available when the
protocol is isisv6, ospfv3, or ripng.
med-value: Specifies the default MED value, in the range of 0 to 4294967295. If no MED is specified, the
cost of a redistributed route will be used as its MED in the BGP routing domain.
route-policy-name: Specifies the name of a routing policy used to filter redistributed routes, a
case-sensitive string of 1 to 63 characters.
Description
Use import-route to redistribute routes from another routing protocol.
Use undo import-route to disable route redistribution from a routing protocol.
By default, IPv6 MBGP does not redistribute routes from any routing protocol.
The ORIGIN attribute of routes redistributed through the import-route command is incomplete.
To Next Page
Loading...
Need help?
General