7
Use undo dot1p-priority to restore the default.
The default 802.1p precedence for IGMP messages is 0.
Examples
# Set the 802.1p precedence for IGMP messages to 3 globally.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] dot1p-priority 3
dscp (IGMP-snooping view)
Syntax
dscp dscp-value
undo dscp
View
IGMP-snooping view
Default level
2: System level
Parameters
dscp-value: Specifies the DSCP value for IGMP messages, in the range of 0 to 63.
Description
Use dscp to set the DSCP value for IGMP messages.
Use undo dscp to restore the default.
The default DSCP value in IGMP messages is 48.
This command applies to only the IGMP messages that the local switch generates when the switch or its
port acts as a member host, rather than those forwarded ones.
Examples
# Set the DSCP value to 63 for IGMP messages.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] dscp 63
entry-limit (IGMP-snooping view)
Syntax
entry-limit limit
undo entry-limit
View
IGMP-snooping view
Default level
2: System level
To Next Page
Loading...
Need help?
General