Basic Operation
OPERATION GUIDE 3-31
3
Sending
This machine can send a scanned image as an attachment to an E-mail message or to a PC linked to the
network. In order to do this, it is necessary to register the sender and destination (recipient) address on the
network.
A network environment which enables the machine to connect to a mail server is required. It is recommended
that a Local Area Network (LAN) be used to assist with transmission speed and security issues.
At the same time as you send a scanned image, you can also print the image or send it to the Document Box.
To use the Scanning Function perform the following steps:
⢠Program the settings, including the E-mail setting on the machine.
⢠Use COMMAND CENTER (the internal HTML web page) to register the IP address, the host name of the
SMTP server, and the recipient.
⢠Register the destination in the Address Book or One Touch keys.
⢠When the PC Folder (SMB/FTP) is selected, it is necessary to share the destination folder. For setting-up
the PC Folder, contact your administrator.
⢠Creating/Registering a Document Box (when a Document Box is selected as the destination)
⢠Detailed transmission settings (to select a Document Box as the destination or to print and send the image
at the same time)
Follow the steps below for basic sending. The following four options are available.
⢠Send as E-mail: Sends a scanned original image as an E-mail attachment...page 3-32
⢠Send to Folder (SMB): Stores a scanned original image in a shared folder of any PC...page 3-33
⢠Send to Folder (FTP): Stores a scanned original image in a folder of an FTP server...page 3-33
⢠Send to Document Box: Sends a document stored in a document box on this machine...page 6-6
⢠Image Data Scanning with TWAIN / WIA: Loads the document data stored in a Custom Box to a PC...Refer
to the TWAIN/WIA Driver Operation Guide
NOTE: Different sending options can be specified in combination. Refer to Sending to Different Types of
Destinations (Multi Sending) on page 3-39.