Copying Functions
4-42 OPERATION GUIDE
Continuous Scan
When a large number of originals cannot be placed in the document processor at one time, the originals can be
scanned in separate batches and then copied as one job. With this function, originals are scanned until you
press [Scan Finish].
Any of the following settings can be changed during scanning.
ā¢ Original size selection
ā¢ Original orientation
ā¢ Image quality selection
ā¢ Type of original (2-sided/book original)
ā¢Zoom
ā¢ Border erase
ā¢Density
ā¢ Color Selection
If you use Job Build, you can insert a blank paper during scanning or a blank page during duplex copying.
The procedure for making copies using Continuous Scan is explained below.
1 Press the Copy key.
2 Press [Advanced Setup] and then [Continuous
Scan].
3 If Continuous Scan is selected, press [On].
If Job Build is selected, press [Job Build] and select
desired binding orientation.
4 Press [OK].
5 Place the originals in the document processor or on
the platen and press the Start key.
If [Job Build] is selected, the next page can be
changed. Press [Sheet Insertion] to insert a blank
paper. Press [Next Copy: On Back] in duplex
copying to print the next page on back page.
Status
10/10/2008 10:10
Copies
Cancel Finish Scan
Scanner Setting
Original
Size
Original
Orientation
Original
Image
2-sided/Book
Original
Zoom
Border Erase
Density
1
Next Copy: On Front
Sheet
Insertion
Next Copy:
On Back
Finishing
pages
Scan next original(s).
Place the originals and press Start key.
Press [Finish Scan] to start copying.
Job No.: Job Name: User Name:
000021
doc20080505113414 -----
1/2
ćŖćŖ
To Next Page
Loading...
Need help?
General
