Lenze i510 Series Commissioning

9.4.2 Node address seng
Each network node must be provided with a unique node address.
The parameters for addressing the device are described below.
Details
•
The node address can be set in 0x2301:001 (P510.01).
•
The seng that is acve when the inverter is switched on is the eecve seng.
•
The acve node address is shown in 0x2302:001 (P511.01).
Parameter Name / value range / [default seng] Info
0x2301:001
(P510.01)
CANopen sengs: Node ID
(CANopen se.: Node ID)
1 ... [1] ... 127
Seng of the node address.
•
A change in the node address will not be eecve unl a CAN Reset
Node is performed.
0x2302:001
(P511.01)
Acve CANopen sengs: Acve node ID
(CANopen diag.: Acve node ID)
•
Read only
Display of the acve node address.
0x2303
(P509.00)
CANopen switch posion
(CANopen switch)
•
Read only
Display of the DIP switch seng at the last mains power-on.
9.4.3 Baud rate seng
All network nodes must be set to the same baud rate.
The parameters for the baud rate of the device are described below.
Details
•
The baud rate can be set in 0x2301:002 (P510.02).
•
The seng that is acve when the inverter is switched on is the eecve seng.
•
The acve baud rate is displayed in 0x2302:002 (P511.02).
Parameter Name / value range / [default seng] Info
0x2301:002
(P510.02)
CANopen sengs: Baud rate
(CANopen se.: Baud rate)
Seng of the baud rate.
•
A change in the baud rate will not be eecve unl a CAN reset node
is performed.
0 Automac (from version 03.00)
1 20 kbps Seng of the baud rate.
•
A change in the baud rate will not be eecve unl a CAN reset node
is performed.
2 50 kbps
3 125 kbps
4 250 kbps
5 500 kbps
6 800 kbps
7 1 Mbps
0x2302:002
(P511.02)
Acve CANopen sengs: Acve baud rate
(CANopen diag.: Acve baud rate)
•
Read only
Display of the acve baud rate.
0 Automac (from version 03.00)
1 20 kbps
2 50 kbps
3 125 kbps
4 250 kbps
5 500 kbps
6 800 kbps
7 1 Mbps
Conguring the network
CANopen
Baud rate seng
205

Lenze i510 Series Specifications

General

Protection Class	IP20
Overload Capacity	150% for 60 seconds
Enclosure Rating	IP20
Dimensions	Varies by model
Weight	Varies by model
Control Type	V/f control, vector control
Communication Interfaces	CANopen, Modbus RTU, EtherCAT, PROFIBUS, PROFINET
Ambient Temperature	-10°C to +50°C
Braking Resistor	Optional
Safety	STO (Safe Torque Off)
Protection Features	Overcurrent, overvoltage, undervoltage, overtemperature, short circuit
Output Voltage	0 to input voltage
Input Voltage	200-240 V, 380-480 V
Voltage Range	200-240 V, 380-480 V
Frequency Range	0 to 599 Hz