3-7. MAINTENANCE Menu
M01: SERIAL NO SET
Menu Image Item Settings Description
<SERIAL NO SET> → M01 TOP
SERIAL NO:00000000
NAME: HDCU2500
DEST: SYL
WRITE
EDIT-CANCEL
TIME-RESET
FACTORY-RECALL
SERIAL NO 00000000 to
99999999
The setup information is stored in the
EEPROM (IC101) on the AT-167A
board.
To modify the setup information, set
S101 (PROTECT) on the AT-167A
board to OFF.
NAME HDCU2500
DEST SYL Com-
mon
J Japan
UC United
States
CE Europe
WRITE Writes the above setup information
to the EEPROM. Place the cursor at
“WRITE” and turn the CANCEL/
ENTER lever to the ENTER side. A
message “SERIAL NO WRITE
OK?” appears. Turn the CANCEL/
ENTER lever to the ENTER side
again to perform the processing.
EDIT CANCEL Restores the setup information dur-
ing editing to the previous informa-
tion before editing.
Place the cursor at “EDIT-CAN-
CEL” and turn the CANCEL/ EN-
TER lever to the ENTER side.
A message “EDIT DATA CANCEL
OK?” appears.
Turn the CANCEL/ENTER lever to
the ENTER side again to perform the
processing.
TIME-RESET Resets the timer for displaying pow-
er-on hours.
FACTORY-RE-
CALL
Resets all the setting values except
the following items to the factory
settings.
• Media access control (MAC)
address
• Serial number
• Power-on hours display timer
• Setting values stored in the EE-
PROM on the AT-167A board
through the PLD.
Processing result indication
Setting Item Normal end Abnormal end Description
WRITE SERIAL NO
WRITE OK
EEPROM WRITE
PROTECTED
S101 (PROTECT) on the
AT-167A board is set to ON.
MODEL NAME IS
WRONG
The NAME (model name) set-
ting is not correct.
DEST NAME IS
WRONG
The DEST (destination) setting
is not correct.
SERIAL NO
WRITE NG
Data cannot be written to the
EEPROM.
EDIT-CANCEL EDIT DATA
CANCEL OK
–
HDCU2500
3-39
To Next Page
Loading...
Need help?
General
