Sony HDCU2500 Maintenance Manual

M02: Firmware Update
Menu Image Item Description
<FirmwareUpdate>→ M02 TOP
ROM-SEL:Upper
[BOOT]
HDCU2000
1.00 XX.XX.XX
VERSION UP EXEC
[MAIN]
HDCU2000
1.00 XX.XX.XX
VERSION UP EXEC
ROM-SEL Fixed to Upper (Factory use)
BOOT BOOT version information.
VERSION UP EXEC Place the cursor at “VERSION UP EXEC” and
turn the CANCEL/ENTER lever to the ENTER
side.
A message “UPDATE BOOT BLOCK ?” ap-
pears.
Turn the CANCEL/ENTER lever to the ENTER
side again to perform the processing.
MAIN MAIN version information.
VERSION UP EXEC Place the cursor at “VERSION UP EXEC” and
turn the CANCEL/ENTER lever to the ENTER
side.
A message “UPDATE BOOT BLOCK ?” ap-
pears.
Turn the CANCEL/ENTER lever to the ENTER
side again to perform the processing.
If an error is detected during memory stick read operation, any of the following messages is displayed.
• MS NOT FOUND: Memory stick is not inserted.
• MS-FILE NOT FOUND: The target file is not found in the memory stick.
• MS-FILE SIZE ERR: File size is not correct.
• MS-FILE READ ERR: Memory stick read error.
M03: ANALOG ADJUST
Menu Image Item Settings Description
<ANALOG ADJUST> → M03 TOP
PROMPTER1 LEVEL: 0
PROMPTER2 LEVEL: 0
PROMPTER1
LEVEL
±99 Prompter 1 signal level adjustment
PROMPTER2
LEVEL
±99 Prompter 2 signal level adjustment
HDCU2500
3-40

Sony HDCU2500 Specifications

General

Brand	Sony
Model	HDCU2500
Category	Control Unit
Language	English