Cisco Firepower 4100 Command Reference

set remote-ike-ident
To specify the remote peer IKE identity for an IPSec tunnel connection, use the set remote-ike-ident command.
set remote-ike-ident remote_ID
Syntax Description
The IKE identification of the remote peer; maximum of 510 characters.
remote_ID
Command Modes
Connection (/security/ipsec/connection) mode
Command History
ModificationRelease
Command added.1.1(1)
Usage Guidelines
Use this command to specify the remote peerʼs IKE ID for an IPSec connection. This identification is used
for peer validation during IKE negotiations.
Example
This example shows how to specify the remote IKE ID for an IPSec connection:
FP9300-A # scope security
FP9300-A /security # scope ipsec
FP9300-A /security/ipsec # enter connection testconn
FP9300-A /security/ipsec/connection # set remote-ike-ident 203.0.113.12
FP9300-A /security/ipsec/connection* # commit-buffer
FP9300-A /security/ipsec/connection #
DescriptionCommand
Creates a new IPSec connection.create connection
Sets the remote IP address for an IPSec connection.set remote-addr
Cisco Firepower 4100/9300 FXOS Command Reference
219
S Commands
set remote-ike-ident

Cisco Firepower 4100 Specifications

General

Brand	Cisco
Model	Firepower 4100
Category	Firewall
Language	English