Cisco Firepower 4100 Command Reference

Object Commands
Four general commands are available for object management:
• create object
• delete object
• enter object
• scope object
You can use the scope command with any managed object, whether a permanent object or a user-instantiated
object. The other commands allow you to create and manage user-instantiated objects. For every create object
command, a corresponding delete object and enter object command exists.
In the management of user-instantiated objects, the behavior of these commands depends on whether the
object exists, as described in the following tables:
Table 2: Command Behavior If The Object Does Not Exist
BehaviorCommand
The object is created and its configuration mode, if applicable, is entered.
create object
An error message is generated.
delete object
The object is created and its configuration mode, if applicable, is entered.
enter object
An error message is generated.
scope object
Table 3: Command Behavior If The Object Exists
BehaviorCommand
An error message is generated.
create object
The object is deleted.
delete object
The configuration mode, if applicable, of the object is entered.
enter object
The configuration mode of the object is entered.
scope object
Cisco Firepower 4100/9300 FXOS Command Reference
7
CLI Overview
Object Commands

Cisco Firepower 4100 Specifications

General

Brand	Cisco
Model	Firepower 4100
Category	Firewall
Language	English