Cisco Firepower 4100 Command Reference

connect fxos: Command List
After you have used the Supervisor connect fxos command to connect to the FXOS CLI shell for the switching
fabric, the following commands are available in that shell. See connect adapter, on page 37 for information
about the connect fxos command.
NTP and Ethanalyzer configuration; many show commands (?); show running-configuration returns only
SAN and LAN config, not entire fabric interconnect config
Table 9: Commands Available in the FXOS Shell for the Switching Fabric
Additional InformationCommand
Reset functions
counters - Clear counters
logging - Clear logging information
mac - MAC
clear
CLI commands
var - Define a variable
cli
Debugging functions; see following tabledebug
Enable filtering for debugging functions
ip - IP events
ipv6 - IPv6 events
pktmgr - Pm debug-filter
routing - Routing events
debug-filter
Configure Cisco packet analyzer
local - Start local capture of frames to Sup
ethanalyzer
Negate a command or set its defaults
debug - Debugging functions
debug-filter - Enable filtering for debugging functions
ethanalyzer - Configure cisco packet analyzer
terminal - Set terminal line parameters
test - Test command
no
NTP configuration
sync-retry - Retry synchronization with configured servers
ntp
Show running system information; see following tableshow
Cisco Firepower 4100/9300 FXOS Command Reference
396
connect shell Commands
connect fxos: Command List

Cisco Firepower 4100 Specifications

General

Brand	Cisco
Model	Firepower 4100
Category	Firewall
Language	English