Cisco Firepower 4100 Command Reference

connect ftd
To connect to the Firepower Threat Defense (FTD) CLI, use the connect ftd command.
connect ftd name
Syntax Description
Specifies the FTD application instance name, which is the same as the logical
device name. If you have multiple application instances for an application type,
you must specify the name of the instance. To view the instance names, enter
the command without a name.
name
Command Modes
connect module/
Command History
ModificationRelease
Added the name argument. The escape character was changed to exit from
Ctrl-a, d.
2.4(1)
Command added.1.1(4)
Usage Guidelines
See the FTD documentation for commands available from the CLI.
To exit the FTD console, enter exit. For pre-2.4(1) versions, enter Ctrl-a, d
Return to the supervisor level of the FXOS CLI:
Exit the console:
Enter ~, then quit to exit the Telnet application.
Example:
> exit
Firepower-module1> ~
telnet> quit
firepower#
Exit the Telnet session:
Enter Ctrl-], .
Example:
> exit
Firepower-module1> Ctrl-], .
firepower#
Example
This example shows how to connect to the FTD CLI on module 1:
Cisco Firepower 4100/9300 FXOS Command Reference
42
A – R Commands
connect ftd

Cisco Firepower 4100 Specifications

General

Brand	Cisco
Model	Firepower 4100
Category	Firewall
Language	English