Cisco Firepower 4100 Command Reference

connect fxos
To connect to the fxos command shell, use the connect fxos command.
connect fxos [a]
Syntax Description
(Optional) Connects to fabric a.
The fabric ID is always a. If you omit the fabric ID, you are
connected to fabric A.
Note
a
Command Modes
Any command mode
Command History
ModificationRelease
Command added.1.1(1)
Usage Guidelines
To exit the fxos mode, enter exit.
Example
The following example shows how to connect to the fxos command shell, and view available
commands:
firepower# connect fxos
firepower(fxos)# ?
clear Reset functions
cli CLI commands
debug Debugging functions
debug-filter Enable filtering for debugging functions
ethanalyzer Configure cisco packet analyzer
no Negate a command or set its defaults
ntp NTP configuration
show Show running system information
system System management commands
terminal Set terminal line parameters
test Test command
undebug Disable Debugging functions (See also debug)
end Go to exec mode
exit Exit from command interpreter
pop Pop mode from stack or restore from name
push Push current mode to stack or save it under name
where Shows the cli context you are in
firepower(fxos)# exit
firepower#
Related Commands
DescriptionCommand
Connects to a remote debug shell while connected to a specific adapter.connect local-mgmt
Cisco Firepower 4100/9300 FXOS Command Reference
44
A – R Commands
connect fxos

Cisco Firepower 4100 Specifications

General

Brand	Cisco
Model	Firepower 4100
Category	Firewall
Language	English