show server adapter
To display information about network adapters in a server, use the show server adapter command.
show server adapter [server_id|detail|identity|inventory|status|uuid dynamic_uuid]
Syntax Description
(Optional) Displays information about network adapters in a specific server,
expressed as chassis-number/server-number (rack ID is not a valid option).
The keyword detail is available with this option.
server_id
(Optional) Displays detailed information in list form.detail
(Optional) Displays complete identity information for each available adapter.
The keywords uuid and server_id are available with this option.
identity
(Optional) Lists installed network adapters. The keywords detail , uuid and
server_id are available with this option.
inventory
(Optional) Displays overall status of installed network adapters. The keywords
detail , uuid and server_id are available with this option.
status
(Optional) Displays information about network adapters in a particular server,
specified using its dynamic universally unique identifier (UUID); entered in
the form NNNNNNNN-NNNN-NNNN-NNNN-NNNNNNNNNNNN. The keyword detail is
available with this option.
uuid dynamic_uuid
Command Modes
Any command mode
Command History
ModificationRelease
Command added.1.1(1)
Usage Guidelines
By default, this commands lists the adapters available on each server. This is the same information displayed
with the inventory keyword.
Example
This example shows how to display identity information about the installed network adapters:
firepower# show server adapter identity
Server 1/1:
Burned-In UUID: 84928111-2710-4e7c-b664-91bce5b5dfbd
Dynamic UUID: 84928111-2710-4e7c-b664-91bce5b5dfbd
Adapter 1:
Product Name: Cisco Firepower 9000 series MLOM Adapter
PID: FPR-C9300-MP
VID: V01
Vendor: Cisco Systems Inc
Serial: JAD190702J1
Revision: 0
Eth Interface:
Cisco Firepower 4100/9300 FXOS Command Reference
327
S Commands
show server adapter