Cisco Firepower 4100 Command Reference

download image
To copy an FXOS firmware image to the Firepower 4100/9300 chassis, use the download image command
in firmware mode.
To copy a logical device software image to the Firepower 4100/9300 chassis, use the download image
command in application software (/ssa/app-software) mode.
download image {ftp:|scp:|sftp:|tftp:|usbA:|usbB:}
Syntax Description
(Optional) Specifies the URI of an image file to be imported via FTP (File
Transfer Protocol).
ftp://server-ip-addr/path
(Optional) Specifies the URI of an image file to be imported via SCP (Secure
Copy Protocol).
scp://username@
server-ip-addr/path
(Optional) Specifies the URI of an image file to be imported via SFTP (SSH
File Transfer Protocol or Secure File Transfer Protocol).
sftp://username@
server-ip-addr/path
(Optional) Specifies the URI of an image file to be imported via TFTP (Trivial
File Transfer Protocol).
TFTP has a file size limitation of 32 MB. Because firmware bundles
can be much larger than that, we recommend that you do not use
TFTP for firmware downloads.
Note
tftp://username@
server-ip-addr:port-num/path
(Optional) Specifies the path to an image file to be imported from a connected
USB Type A device.
usbA:/path
(Optional) Specifies the path to an image file to be imported from a connected
USB Type B device.
usbB:/path
Command Modes
Firmware (/firmware) mode
Application software (/ssa/app-software) mode
Command History
ModificationRelease
Command added.1.1(1)
Usage Guidelines
Be sure you have the location address and authentication credentials for image file access, as well as the fully
qualified name of the file.
FXOS stores firmware images in bootflash on the fabric interconnect.
In firmware mode, you can use the show package image_name detail command to monitor the image download
process. The output display does not refresh automatically, so you may have to enter the command multiple
times until the task State is “Downloaded.”
In firmware mode, and in application software mode, you can use the show download-task command to
monitor the image download process. The output display does not refresh automatically, so you may have to
enter the command multiple times.
Cisco Firepower 4100/9300 FXOS Command Reference
92
A – R Commands
download image

Cisco Firepower 4100 Specifications

General

Brand	Cisco
Model	Firepower 4100
Category	Firewall
Language	English