Cisco Firepower 4100 Command Reference

connect vdp
To connect to the Radware DefensePro (vDP) CLI, use the connect vdp command.
connect vdp [name]
Syntax Description
(Optional) Specifies the vDP application instance name, which is the same as
the main application logical device/application instance name.
name
Command Modes
connect module/
Command History
ModificationRelease
Added the name argument.
2.4(1)
Command added.1.1(4)
Usage Guidelines
See the vDP documentation for commands available from the CLI.
To exit the vDP console, enter Ctrl-], .
Return to the supervisor level of the FXOS CLI:
Exit the console:
Enter ~, then quit to exit the Telnet application.
Example:
> Ctrl-], .
Firepower-module1> ~
telnet> quit
firepower#
Exit the Telnet session:
Enter Ctrl-], .
Example:
> Ctrl-], .
Firepower-module1> Ctrl-], .
firepower#
Example
This example shows how to connect to the vDP CLI on module 1:
firepower# connect module 1 console
Telnet escape character is '~'.
Trying 127.5.1.1...
Connected to 127.5.1.1.
Cisco Firepower 4100/9300 FXOS Command Reference
50
A – R Commands
connect vdp

Cisco Firepower 4100 Specifications

General

Brand	Cisco
Model	Firepower 4100
Category	Firewall
Language	English