Cisco Firepower 4100 Command Reference

connect cimc: Command List
After you have used the Supervisor connect cimc command to connect to the CIMC firmware debug utility
for a specific module, the following commands are available in that shell. See connect adapter, on page 37
for information about the connect cimc command.
This utility provides access to a read-only shell with commands that let you view real-time CIMC debug
information. These commands are used mainly for troubleshooting CIMC issues: viewing alarms, system
event logs, on-board failures, and power controls.
Table 8: Commands Available in the CIMC Debug Shell
Additional InformationCommand
Displays the current StatusLED state, and which sensors are in alarm, if any.
Alarm Levels:
1 - OK (GREEN ON)
2 - Mem Init (GREEN BLINK)
3 - Mild Fault (AMBER ON)
4 - Severe Fault (AMBER BLINK)
alarms
Lists the Core Dump Directory.cores
Exits from the CIMC subshell.exit
Lists all field-replaceable unit (FRU) device information.fru
Entering just the command help lists all available commands. Entering help
cmd_name, or cmd_name ?, shows help information for the specfied command.
help [COMMAND]
Displays I
2
C controller register information, driver counters, and multi-master
debug trace data.
i2cstats
Displays software image version and status information.images
Displays current MCtools state information: socket and share-file cache size
information.
mctools
Lists memory and load statistics.memory
messages [dump|follow|tail]
dump - Dump the /var/log/messages file
follow - Tail and Follow /var/log/messages file
tail - Dump the last 100 messages
messages
Show the mezz card 1 FRU informationmezz1fru
Cisco Firepower 4100/9300 FXOS Command Reference
394
connect shell Commands
connect cimc: Command List

Cisco Firepower 4100 Specifications

General

Brand	Cisco
Model	Firepower 4100
Category	Firewall
Language	English