Cisco Firepower 4100 Command Reference

connect adapter: Command List
After you have used the Supervisor connect adapter command to connect to the command shell for a specific
adapter, the following commands are available in that shell. See connect adapter, on page 37 for information
about the connect adapter command.
These commands should be used only when troubleshooting virtualized network adapters with Cisco TAC
supervision.
Attention
Table 5: Commands Available in the Adapter ʼ s Primary Command Shell
Additional InformationCommand
Connects to the debug shell; provides access to the commands listed in the
following table.
connect
Exits from the adapter command shell.exit
Lists the commands available in this shell.help
Shows a list of commands issued since entering this shell.history
Shows firmware versions on the adapter.show-fwlist
Show adapter identityshow-identity
Show adapter phy infoshow-phyinfo
Show adapter statusshow-systemstatus
The following commands are available in the debug subshell; accessed by entering the connect command in
the adapterʼs primary command shell.
Table 6: Commands Available in the Adapter Debug Subshell
Additional InformationCommand
Attaches to the adapterʼs fabric login service; provides access to the commands
listed in the following table.
attach-fls
Attaches to the Master Control Program. A large number of debug-information
commands are available. Again, these commands are for use only with Cisco
TAC guidance.
attach-mcp
Launches a Fibre Channel performance monitor.estat
Exits from this subshell.exit
Lists the commands available in this subshell.help
Cisco Firepower 4100/9300 FXOS Command Reference
392
connect shell Commands
connect adapter: Command List

Cisco Firepower 4100 Specifications

General

Brand	Cisco
Model	Firepower 4100
Category	Firewall
Language	English