Cisco Firepower 4100 Command Reference

show subinterface
To show information about the subinterface, use the show subinterface command.
show subinterface [detail]
Syntax Description
Shows information for each subinterface in a non-table format.detail
Command Modes
scope eth-uplink/scope fabric a/scope interface/
scope eth-uplink/scope fabric a/create port-channel/
Command History
ModificationRelease
Command added.2.4(1)
Usage Guidelines
Subinterfaces are supported for container instances only.
Example
The following is sample output from the show subinterface command.
firepower# scope eth-uplink
firepower /eth-uplink # scope fabric a
firepower /eth-uplink/fabric # enter interface ethernet1/8
firepower /eth-uplink/fabric/interface # show subinterface
Sub Interface:
Sub-If Id Sub-Interface Name VLAN Port Type
---------- ------------------ ----------- ---------
100 Ethernet1/5.100 100 Data
The following is sample output from the show subinterface detail command.
firepower# scope eth-uplink
firepower /eth-uplink # scope fabric a
firepower /eth-uplink/fabric # enter interface ethernet1/8
firepower /eth-uplink/fabric/interface # show subinterface detail
Sub Interface:
Sub-If Id: 100
Sub-Interface Name: Ethernet1/5.100
VLAN: 100
Port Type: Data
Related Commands
DescriptionCommand
Creates an EtherChannel (port channel).create port-channel
Adds a subinterface.create subinterface
Cisco Firepower 4100/9300 FXOS Command Reference
360
S Commands
show subinterface

Cisco Firepower 4100 Specifications

General

Brand	Cisco
Model	Firepower 4100
Category	Firewall
Language	English