Cisco Firepower 4100 Command Reference

connect local-mgmt
To connect to the local-mgmt command shell, use the connect local-mgmt command.
connect local-mgmt [a]
Syntax Description
(Optional) Connects to fabric a.
The fabric ID is always a. If you omit the fabric ID, you are
connected to fabric A.
Note
a
Command Modes
Any command mode
Command History
ModificationRelease
Command added.1.1(1)
Usage Guidelines
Refer to connect local-mgmt: Command List, on page 409 for additional information.
To exit the local-mgmt mode, enter exit.
Example
The following example shows how to connect to the local-mgmt command shell, and view available
commands:
firepower# connect local-mgmt
firepower(local-mgmt)# ?
cd Change current directory
clear Clear managed objects
cluster Cluster mode
connect Connect to Another CLI
copy Copy a file
cp Copy a file
delete Delete managed objects
dir Show content of dir
enable Enable
end Go to exec mode
erase Erase
erase-log-config Erase the mgmt logging config file
exit Exit from command interpreter
fips FIPS compliance
ls Show content of dir
mgmt-port Management Port
mkdir Create a directory
move Move a file
mv Move a file
ping Test network reachability
ping6 Test IPv6 network reachability
pwd Print current directory
reboot Reboots Fabric Interconnect
restore-check Check if in restore mode
rm Remove a file
rmdir Remove a directory
Cisco Firepower 4100/9300 FXOS Command Reference
46
A – R Commands
connect local-mgmt

Cisco Firepower 4100 Specifications

General

Brand	Cisco
Model	Firepower 4100
Category	Firewall
Language	English