Delta DVP-ES3 Series Hardware Manual

DVP-ES3/EX3/SV3/SX3 Series Hardware and Operation Manual
6-4
_6
6.2 Procedure for Creating a Project in ISPSoft
This section shows you the procedure for creating a project in ISPSoft. You can adjust the procedure
according to your needs.
 Hardware configuration
You set the parameters such as a range of latched devices and a port number in a PLC. You configure
the modules with a DVP-ES3 Series CPU module, and set the parameters in these modules.
 Network configuration
If a system uses a network architecture, or devices need to exchange data, use the network configuration
tool
NWCONFIG
in ISPSoft to configure a network and exchange data with COM as well as Ethernet.
 Programming
After you write a program in ISPSoft, compile the program. If the compiling is unsuccessful, messages in
the
Compile Message
page show where the errors occur.
 Testing and debugging
Download the compiled program, the hardware configuration, and the network configuration to a PLC.
You can then test and debug the program online with the functions provided by ISPSoft.
Because the example introduced in this chapter does not discuss a network configuration, you only perform
the following procedure.

Delta DVP-ES3 Series Specifications

General

Brand	Delta
Model	DVP-ES3 Series
Category	Controller
Language	English