DVP-ES3 Series Operation Manual
Revision History
st
The first version was published.
2
nd
1. Changed the name of this manual from DVP-ES3
Series Operation Manual to DVP-ES3 Series Hardware
and Operation Manual to correspond to the main idea
of this manual better.
2. Added new product information, DVP02PU-E2, in every
chapter.
3. Chapter 1: Updated the overview contents in Section
1.2, updated contents of high efficiency and serial
control interface with multiple function in Section 1.3.
4. Chapter 2: Updated ingress protection (IP ratings) and
safety ratings in Section 2.1. Added information
concerning communication port isolation for
DVP32ES311T and updated input voltage / current,
input isolation, leakage current, maximum load of
resistance, inductance and bulb, minimum load, input
isolation, and life cycle curve explanation in Section
2.2.2 and 2.3. Updated information concerning
isolation in Section 2.4. Updated rated measurement
range, maximum measurable temperature range for
DVP04PT-E2 and DVP06PT-E and updated information
concerning isolation for DVP04TC-E2 in Section 2.5.
Added a new Section “positioning module
specifications” in Section 2.6.
5. Chapter 3: Updated hard disk drive capacity in Section
3.1. Updated ISPSoft installing steps in Section 3.1.1.
6. Chapter 4: Updated notes on installation in Section
4.2. Added power consumption information for new
modules in Section 4.5.4. Added a new Section “wiring
positioning modules for DVP02PU-E2” in Section 4.10.
7. Chapter 5: Updated what to do with retainable /
non-retainable data when PLC is from OFF to ON in
Section 5.1.3. Added an example of using the counter
with CNT instruction in Section 5.2.10. Added an
example of using the high-speed counter with DCNT
instruction in Section 5.2.11. Added more explanation
on data mapping in Section 5.2.12. Added explanation
on module device function for DVP02PU-E2 in Section
5.3.6.
8. Chapter 6: Updated ISPSoft software example images
and contents accordingly.
2021/09/10