To Next Page

To Previous Page

SC-T7000 series/SC-T5000 series/SC-T3000 series Revision B

ADJUSTMENT CR Related Adjustments 242

Confidential

4.10.7 Auto Bi-D Adjustment, acceleration/deceleration

print correction

PAPER USED

 Type: Premium Glossy Photo Paper (250)

 Size: The maximum paper width which can be set

EXECUTION MODE

Normal mode

PROCEDURE

1. Turn the printer ON.

2. Load the paper into the printer.

3. Start the Service Program and select Auto Bi-D adjustment, acceleration and

deceleration correction.

4. Select All rows adjust or 5 rows adjust and click [Run].

The adjustment pattern will be printed.

5. After the pattern is printed, the printer will automatically scan the pattern and carry

out the adjustment (no manual adjustment is needed).

6. Click [Finish].

7. Turn the printer OFF to finish the adjustment.

Figure 4-27. [Auto Bi-D Adjustment] Screen

Figure 4-28. Adjustment Pattern (all rows)

Figure 4-29. Adjustment Pattern (5 rows)

C H E C K

P O I N T

 All rows adjust

"All rows adjustment" results high accuracy adjustment, but it

takes a long time.

 5 rows adjust

Adjustment accuracy becomes slightly lower with "5 rows

adjustment" since colors used for this adjustment are limited;

however, the adjustment time can be shorten.

Epson SC-T7000 series User Manual

Questions and Answers: