SC-T7000 series/SC-T5000 series/SC-T3000 series Revision B
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 152
Confidential
3.4.4.15 INK TUBE
1. Perform the Ink eject. (p259)
2. Perform the Tube inner pressure reduction. (p248)
3. Remove the UPPER LEFT COVER. (p100)
4. Remove the UPPER SUPPORT R COVER. (p94)
5. Remove the PANEL BOARD. (p120)
6. Remove the TOP COVER. (p85)
7. Remove the FRONT COVER. (p86)
8. Remove the LEFT UPPER COVER & LEFT ROLL COVER. (p101)
9. Remove the RIGHT UPPER COVER & RIGHT ROLL COVER. (p95)
10. Unlock the CR UNIT. (p83)
11. Remove the CR COVER. (p122)
12. Remove the RIGHT LOWER COVER. (p96)
13. Remove the IH COVER. (p89)
14. Remove the CR Sub Fixing Plate. (p124)
15. Remove the two screws, and remove the INK TUBE from the DAMPER KIT.
A) Silver M2.5x16 Machine screw: 2 pcs
Figure 3-101. Removing the INK TUBE (1)
A D J U S T M E N T
R E Q U I R E D
When replacing/removing this part, refer to “4.1.2 Adjustment
Items and the Order by Repaired Part” (p199) and make sure to
perform the specified operations including required adjustment.
C A U T I O N
When the INK TUBE is removed at the following step, ink may
drip off from the tube. Prepare a waste cloth or the like in advance
and be careful not to contaminate the surroundings.
Before installing the joint, make sure the Joint Rubber are
attached to it.
Before attaching the Joint Rubber, let it get wet with cleaning
liquid.
DAMPER KIT
A
A
INK TUBE
Joint Rubber
To Next Page
Loading...
Need help?
General