Suppon the bearing
housing section
of
the brake panel
when
installing.
Apply grease
to
the lips
of
a
new
dust seal [1].
Install the dust seal with the metal plate side facing up
until it is flush with
Ihe
housing end .
TOOLS:
[2J
Driver
[3]
Attachment,
62 x 68 mm
Remove the snap ring [1].
07749-0010000
07746-0010500
Drive Ihe bearings [2]
oul
of the brake panel.
Drive a new bearing
in
to the brake panel with the
sealed side facing down (brake drum side).
TOOLS:
(3J
Driver
(4]
Oil
seal
driver
attachment
[5) Pitot,
28
mm
07749·0010000
07JAD·PH80101
07746-0041100
Drive a new bearing with the sealed side facing up (axle
housing side) using the same tools.
Install
the snap ring into the groove with the chamfered
edge facing the bearing.
Apply grease
to
the seal lips
of
a new dust seal [1].
Install the dust seal into the brake panel so that it
is
flush with the brake panel.
REAR FINAL DRIVE REMOVAL
Drain the gear case oil if the final gear case will be ,
--
disassembled (page 3-17).
Remove the rear
axle (page 20-7).
Support the swingarm and remove the following:
- breather hose
(1
) (from the gear case)
REAR DRIVING MECHANISM
20-9
To Next Page
Loading...
Need help?
General
