ELECTRIC POWER STEERING (EPS: FPM/FPE
model
s)
HOW
TO
TR
OUBLESHOOT
EPS DTC
1,
Questton
the customer about the conditions when the problem occurred. and try to reproduce the same conditions lor
troubleshooting . Find
out
when the EPS indicator came on, such as during EPS control , after
EP$
control, when the vehicle was
al a certain speed, etc.
2. When the EPS indicator does not come on during the lest-ride, but troubleshooting is done based on the DTC, check for loose
connectors, poor terminal contact, etc., in the affected circuil before you start troubleshooting.
3. After troubleshooting, erase the
DlC(s)
and test-ride the vehicle to be sure that the EPS indicator does not come on.
HDS POCKET TESTER INFORMATION
• The HDS can readout and erase the
DIG
(without the torque sensor neutral position).
H
ow
to
co
nnect
the
H
OS
Poc
ket
Tester
Turn the ignition switch OFF,
Remove the seat (page 2-4
),
Remove the OLC
[1)
from the dummy conneclor
[2)
,
Connect Ihe HDS pockel tesler
10
t
he
OLC,
Turn Ihe
ignilion switch ON and engine slop swilch ·0 ", check the DTC and
stored data.
DTC RE
ADOUT
NOTE
121
If
Ihe
HoS
pocket tester
is
not available,
oTC
can be read from the EPS ECU memory by the EPS indicator blinking pattern
(page 24-10
).
After pettorn-ling diagnostJc troubleshooting, erase the OTC(s) (page 24-11) and test-ride the vehicle to be sure
Ihal
the
problem(s) have been removed ,
Start Ihe engine and check the EPS indicator (1),
NOTE
Under normal conditions, the EPS indicalor stays on with the ignition
switch
is
turned ON until the engine slans, and it goes off after starting
the engine.
If
the EPS indicator stays on or blinks
wi
th the engine running, connect the
HDS pocket tester to the OLC (page 24-10).
Read the
OTC, stored data and follow the troubleshooting index
(page 24-16
).
To read the OTC without the
HoS
pocket tester, refer to the following
procedure.
Rea d ing
DTC
wi
th
the
EPS
indicator
1 Remove the OLC from the dummy connector (page 24-10),
2. Short the
OLe
[1)
terminals using the special tool.
TOOL:
(2
] S
CS
servic
e co
nnect
or 070PZ-ZY30100
Co
nn
e
ct
i
on
:
Brown
/red - Green
3,
Turn the ignition switch ON and engine stop switch "0
",
read , note the
EPS Indicator blinks and refer to the troubleshooting index (page 24-16).
24-10
R NI
--
1\1
,n
u
11
I
~I
~
I
PS)
I
,1,
)
'"
1 ...... 1
,-,
-,
-
LI
-
il
I:
e
II!!!I
2 "
,lE
\
121