EasyManuals Logo
Home>Honda>Offroad Vehicle>TRX500FM

Honda TRX500FM Service Manual

Honda TRX500FM
564 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #497 background imageLoading...
Page #497 background image
ELECTRIC SHIFT PROGRAM (ESP: FE/FPE models)
HDS POCKET TESTER INFORMATION
• The HOS can readout
the
OTe , stored
data
, current data and other
peM
condition.
H
ow
to
con
ne
ct
th
e HDS
Pocket
Tester
Turn the Ignition sWitch
OFF
.
Remove the seat (page 2-4).
Remove the
OLe
111
from the
dummy
connector
12]
.
Connect the
HOS pocket tester to the
Ole
.
Turn the ignition switch ON and engine
stop
sW
itch
·0
", check the
OlG
and
stored data.
NOTE'
• Stored data indicates the engine and ESP conditions when the first
malfunction was detected.
PCM
reset
The HOS can reset the
peM
data including the OTG. stored data and
some
learning memory.
DTC
READOUT
NOTE
L-
_____
---'
[1[
If
the
MIL
blinks, refer to "PGM-FI Troubleshooting Information" and troubleshoot the PGM-
FI
system first. Then recheck the
ESP
after erasing the PGM-FI OTC.
After performing diagnostic troubleshooting,
erase
the problem OTC(s) (page 23-12) and test-ride the vehicle to be sure that the
problem(s) have been removed.
Connect the
HOS pocket tester to the OLC (page 23-11
).
Read the DTC , stored data and follow the troubleshooting index (page 23-13).
To
read the OTC
without
the HOS pocket tester, refer to
the
following procedure.
Reading
DTe
with
the
gear
posit
io
n
indicator
Turn the ignition switch ON and
engine
st
op
switch
·0·,
read and note the
rl-:-
[1
~
[
---
------îš­
gear poSition indicator
{II
blinks "- ".
The
number
of
blinks Indicates the current OTC.
Refer to the troubleshooting Index (
page
23-13
).
When retrieving the stored OTC , refer to the following procedures
1. Remove the OLC from the
dummy
connector (page 23-11
).
2. Short the OLC [1) terminals usi
ng
the special tool.
TOOL:
[2] SCS
service
connector
070PZ-ZY30100
Connection
:
Brown
/
red
-
Green
3. Turn the ignition switch
ON
and engine
slop
SWitch
"
0".
read and note
the
gear
position indicator blinks.
The number
of
blinks indicates the stored OTG.
Refer to the troubleshooting index (page 23-13).
['(R) (N)
1
"'-
-
000
[11
(ps) (X)
(41~)
1--1
rl
=F
-
il
J
LI,
=, I!!!I
2
...
·
LE
[2[
23-11
1

Table of Contents

Other manuals for Honda TRX500FM

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honda TRX500FM and is the answer not in the manual?

Honda TRX500FM Specifications

General IconGeneral
BrandHonda
ModelTRX500FM
CategoryOffroad Vehicle
LanguageEnglish

Related product manuals