10
GPS/GPS-A OPERATION
10-24
In the DV mode, this function automatically transmits
the GPS receiver’s current position data, at a selected
interval, and should only be used in Simplex transmis-
sion.
NOTE:
• Your own call sign must be entered to activate the
GPS automatic transmission.
• When the “GPS Select” item on page 16-32 is set to
“OFF” or “Manual,” this function is disabled.
(MENU > GPS > GPS Set > GPS Select)
D
Setting the GPS automatic transmission
Push [MENU] q
to enter the Menu screen.
Push D-pad( w ) to select the root item (“GPS”), and
then push D-pad(Ent).
Push D-pad( e ) to select “GPS Auto TX,” and then
push D-pad(Ent).
Rotate [DIAL] to select a desired position data trans- r
mit interval.
• Selectable settings are OFF, 5*, 10, 30 seconds and 1, 3,
5, 10 and 30 minutes.
* If four GPS sentences are selected in GPS SENTENCE
menu on page 16-41, “5sec” cannot be selected.
• Selecting “OFF” cancels the GPS automatic transmis-
sion.
• The GPS message is also transmitted, if programmed.
Push [MENU] t to exit the Menu screen.
NOTE:
• Use GPS automatic transmission in only the sim-
plex mode.
• GPS automatic transmission through a repeater
may interfere with other communications.
When a GPS message is programmed, the trans-
ceiver transmits it along with the position data. See
page 16-42 for the GPS message programming.
■ GPS Auto transmission for only Simplex
To Next Page
Loading...
Need help?
General
