15
REPEATER AND DUPLEX OPERATIONS
15-6
■ Auto repeater function
When the operating frequency falls within the repeater
output frequency range, the Auto Repeater function
can automatically sets the repeater settings (duplex
ON/OFF, duplex direction, tone encoder ON/OFF).
The Auto repeater function uses the preset repeater
tone frequency and frequency offset.
See page 16-16 for details of the setting.
Push [MENU] .
Push D-pad() to
select, then push
D-pad(Ent).
Push D-pad() to
select, then push
D-pad(Ent).
Frequency range and offset direction D
• U.S.A. version
FREQUENCY RANGE SHIFT DIRECTION
145.200–145.495 MHz “DUP–” is set
146.610–146.995 MHz “DUP–” is set
147.000–147.395 MHz “DUP+” is set
442.000–444.995 MHz “DUP+” is set
447.000–449.995 MHz “DUP–” is set
• Korean version
FREQUENCY RANGE SHIFT DIRECTION
439.000–440.000 MHz “DUP–” is set
D Auto repeater setting
Push [MENU] q to enter the MENU screen.
Push D-pad( w ) to select the root item (“Function”),
and then push D-pad(Ent).
Push D-pad( e ) to select “Auto Repeater,” and then
push D-pad(Ent).
Rotate [DIAL] to select the Auto repeater setting. r
U.S.A. version:
• OFF : The Auto repeater function is OFF.
• ON (DUP) : Turns ON only the duplex operation.
(Default)
• ON (DUP, TONE) : Turns ON the duplex operation and
tone encoder
Korean version:
• OFF : The Auto repeater function is OFF.
• ON : Turns ON the duplex operation and tone encoder.
(Default)
Push [MENU] t to save, and exit the MENU screen.
NOTE: When turned ON, the Auto repeater function
uses the preset repeater tone frequency and frequen-
cy offset. See page 16-16 for details of the setting.
For the U.S.A. and Korean versions:
When turned ON, the Auto repeater function has pri-
ority over the manual duplex setting. If the transmit
frequency changes after setting, the Auto repeater
function may have changed the duplex setting.
[DIAL]
To Next Page
Loading...
Need help?
General
