8
D-STAR OPERATION <BASIC>
8-15
The destination repeater call sign can be directly input.
Hold down q for 1 second.
• The DR mode is selected.
Push D-pad( w ) to select “TO,” and then push D-
pad(Ent).
Push D-pad( e ) to select “Direct Input (RPT).”
Push D-pad(Ent) to enter the edit mode. r
Rotate [DIAL] to select a desired character. t
(Example: J)
• A to Z, 0 to 9, / and a space can be selected.
• Rotate [DIAL] counter clockwise to enter a space.
• Push [CLR]
to delete the selected character, or hold
down [CLR]
to continuously erase the characters,
first to the right, and then to the left of the cursor.
Push D-pad( y ) to move the cursor to the second
digit.
Repeat steps u t and y to enter a name of up to 8
characters, including spaces.
(Example: First, J, then P, then 3, then Y, then D,
then H.)
After entering, push D-pad(Ent) twice. i
• “JP3YDH” is displayed on “TO.”
• After programming, you can correct the call sign in the
DIRECT INPUT (RPT) screen.
• The programmed call sign remains on the DIRECT IN-
PUT (RPT) screen, until inputting a new call sign.
The following settings are also correct.
The repeater node*
is input.
“/” is input.
In this case, the call sign is of
a repeater for a Gateway call.
* Although the repeater node letter is ‘B’ for 430 MHz band,
‘A’ is used in Japan. See page 8-1 for details.
If the programmed call sign is duplicated to the re-
peater list, the name is displayed. (Only when the
name has been programmed.)
Example: Directly input the call sign “JP3YDH”
“TO” (Destination) setting (Continued) ■
D Directly inputting (RPT)
Completed
[DIAL]
To Next Page
Loading...
Need help?
General
