13
SCAN OPERATION
13-10
Memory scan (Continued) ■
D Memory bank scan
A memory bank scan searches through the memory
channels in the selected bank.
• Two or more memory channels, which are not set as skip chan-
nels, must be programmed to start a memory bank scan.
• When the “BANK” item in the MENU screen is set to “OFF,”
a bank scan is not started.
Push [M/CALL] q one or more times to select the
Memory mode.
Push [QUICK] w to open the Quick Menu screen.
Push D-pad( e ) to select “Bank Select,” and then
push D-pad(Ent).
Rotate [DIAL] to select a desired bank group to be r
scanned, and then push D-pad(Ent).
• Only Bank groups that have memory channels assigned
to them are displayed.
Hold down [MODE] t for 1 second.
Push D-pad ( y ) to select the scan type.
• ALL : Full bank scan
• BANK-LINK : Bank link scan
• BANK-A to Z : Bank scan
( Only banks which contain a memory chan-
nel are displayed.)
• DUP : Duplex scan (p. 13-2)
( Appears only when duplex is set on the
channel.)
• TONE : Tone scan (For tone scanning)
Push D-pad(Ent) to start the scan. u
To cancel the scan, hold down [SCAN] i for 1 second.
• Pushing [CLR] also cancels the scan.
NOTE:
• The bank contains only channels which are set as
“SKIP” or “PSKIP” are skipped.
• When the all selected banks contain only channels
which are set as “SKIP” or “PSKIP,” the scan is not
started.
When a signal is received.
Hold down [SCAN]
for 1 second.
Push [M/CALL] .
Blinks
Blinks
Bank channel
number
Blinks
Blinks
The S-meter shows the
received signal strength.
Push D-pad() to
select, then push
D-pad(Ent).
Convenient! ✓
Holding down [SCAN] and rotate [DIAL] also se-
lects the scan type. The scan immediately starts when
[SCAN] is released.
[DIAL]
To Next Page
Loading...
Need help?
General
