Icom ID-51A Advanced Instructions

13
SCAN OPERATION
13-5
■ VFO scan
There are 6 scan types: Full scan, Band scan, Program
scan, Program link scan, Duplex scan and Tone scan.
NOTE:
The frequencies that are set as skip channels
“PSKIP” are skipped during a scan.
When the “PROGRAM SKIP” item in the MENU screen
is set to OFF, the frequencies that are set as skip chan-
nels “PSKIP”, are not skipped during a scan.
(MENU > Scan > Program Skip)
D VFO mode scan
Push [V/MHz] q to select the VFO mode.
Push [MODE] w to select the operating mode.
Hold down [SCAN] e for 1 second.
Push D-pad( r ) to select the scan type.
• ALL : Full scan.
• BAND : Band scan.
• P-LINK0–9 : Program link scan.
• P00–24 : Program scan.
• DUP : Duplex scan (p. 13-2).
( Appears only when duplex is set.)
• TONE : Tone scan.
(For tone squelch scanning)
D-pad
(�)
(Ent)
Push D-pad(Ent) to start the scan. t
• ALL : The decimal point and “ALL” blinks.
• BAND : The decimal point and “BND” blinks.
• P-LINK0–9/P00–24
: The decimal point and Scan edge number blink.
• DUP : The decimal point and “DUP+”/“DUP–” blink.
• If desired, rotate [DIAL] to switch the scanning direction
during a scan.
• If desired, push [MODE]
to change the operating
mode during a scan.
• The scan resumes even while the MENU screen is dis-
played.
To cancel the scan, hold down [SCAN] y for
1 second.
• Pushing [CLR] also cancels the scan.
Convenient! ✓
Holding down [SCAN] and rotate [DIAL] also se-
lects the scan type. The scan immediately starts when
[SCAN] is released.
Hold down
[SCAN]
for 1 second.
Example: Full scan in the FM mode.
When a signal is received.
[DIAL]
Blinks
Blinks
The S-meter shows the
received signal strength.
Blinks
Blinks
Push D-pad() to
select, then push
D-pad(Ent).
Previous view

Icom ID-51A Specifications

General

Brand	Icom
Model	ID-51A
Category	Transceiver
Language	English