Appendix-650 Spline interpolation
7Appendix
Changes cannot be saved in a spline file being used for spline interpolation. If
saving is attempted, error L2610 (can’t change spline file) will occur. Do not per-
form save to a spline file being used.
(10) Deleting a spline file
Select the spline file to be deleted from the project tree, and right-click the mouse.
A context menu will appear, and a confirmation dialog will appear when [Delete] is clicked.
Fig.7-66:Deleting a spline file
When the [Yes] button is clicked, the designated spline file will be deleted.
When the [No] button is clicked, the deletion process will be canceled.
(11) Changing the spline No.
Select the target spline file from the project tree, and click the right mouse button.
A context menu will appear. When [Renumber] is clicked, a dialog for designating a new spline No. will
appear.
Fig.7-67:Changing the spline No.
When a new spline No. is designated and the [OK] button is clicked, the spline No. of the designated spline
file will change.
The spline No. change process is canceled when the [Cancel] button is clicked.
To Next Page
Loading...
Need help?
General
