Mitsubishi MELSEC Q Series User Manual

14
COMMUNICATIONS BETWEEN CPU MODULES
14.4 Programmable controller Remote Control Function
14 - 18
9
UTILITY OPERATION
10
FUNCTIONS AND PROGRAMMING
11
OVERVIEW OF MULTIPLE CPU SYSTEM
12
MULTIPLE CPU SYSTEM CONFIGURATION
13
MULTIPLE CPU SYSTEM CONCEPT
14
COMMUNICATIONS BETWEEN CPU MODULES
15
PARAMETERS ADDED FOR MULTIPLE CPU
16
PRECAUTIONS FOR USE OF AnS SERIES MODULE
14.4 Programmable controller Remote Control Function
(1) Programmable controller remote control function
This function controls the execution status of the programmable controller CPU from
the C Controller module.
Use the MELSEC data link function to create the user program of the C Controller
module.
(2) Function
The following indicates the function used for the remote control.
Remark
Refer to Chapter 10 for details of the MELSEC data link functions.
Figure 14.15 Programmable controller remote control
Table14.12 Function used for remote control
Function name Function
mdControl
Performs remote RUN/STOP/PAUSE of the programmable
controller CPU.
Programmable
controller CPU
RUN
STOP
PAUSE
Execution status
C Controller module
/* Controls the execution status of the programmable
controller CPU */ ret = mdControl(path, stno, code);
1)
1) Controls the execution status of the
programmable controller CPU
from the C Controller module.

Mitsubishi MELSEC Q Series Specifications

General

Brand	Mitsubishi
Model	MELSEC Q Series
Category	Controller
Language	English