9
UTILITY OPERATION
9.2 C Controller Setting Utility
9.2.6 Operating Online operation screen
9 - 35
9
UTILITY OPERATION
10
FUNCTIONS AND
PROGRAMMING
11
OVERVIEW OF
MULTIPLE CPU
SYSTEM
12
MULTIPLE CPU
SYSTEM
CONFIGURATION
13
MULTIPLE CPU
SYSTEM
CONCEPT
14
COMMUNICATIONS
BETWEEN CPU
MODULES
15
PARAMETERS
ADDED FOR
MULTIPLE CPU
16
PRECAUTIONS FOR
USE OF AnS SERIES
MODULE
9.2.6 Operating Online operation screen
POINT
1. If a communication error has occurred during connection, make the
connection target setting again.
2. Communication are not available during reset of the C Controller module.
Start communication after terminating the reset process.
(1) Online operation screen
This screen allows parameter read/write/verification, remote operation, clock setting,
and IP address setting for the C Controller module.
(To next page)
Figure 9.33 Online operation screen
Table9.15 Explanation of Online operation screen
Item Description
Reference
section
Read parameter
button
Reads parameters from the C Controller module.
Write parameter
button
Writes parameters, which were set on the C Controller setting utility, to the
C Controller module.
The written parameters become valid when the C Controller module is
powered off and then on or is reset.
This button can be used only when "Write authority" was checked at the
time of connection target setting (
Section 9.1.3).
This button cannot be used without "Write authority". ( Section
9.1.3).
*1
"It clears all parameters
before writing" check box
Clicking the above button with this check box checked clears all
parameters (including the CC-Link module parameters, MELSECNET/H
module parameters, and intelligent function module parameters) before
the parameters are written.
Module information Event history SRAM monitor Module monitor
Online operation
Read
Write
Write
To Next Page
Loading...
Need help?
General
