Mitsubishi MELSEC Q Series User Manual

9 - 72
9.3 CC-Link utility
9.3.5 Operating Parameter setting screen
9
UTILITY OPERATION
9.3.5 Operating Parameter setting screen
This screen allows the parameter setting of the CC-Link module.
POINT
1. If any entered parameter is erroneous when attempting to switch the screen
to another, a warning message appears and the screen will not be switched.
Switch the tab after correcting the erroneous parameter.
2. To update the settings into the C Controller module, write the parameters from
the <<Online operation>> tab and power off and then on or reset the C
Controller system.
(1) Parameter setting screen
Figure 9.57 Parameter setting screen

Mitsubishi MELSEC Q Series Specifications

General

Brand	Mitsubishi
Model	MELSEC Q Series
Category	Controller
Language	English