3 I/O Ports, Slave Configuration, and Unit Configuration
3-2
NJ-series CPU Unit Software User’s Manual (W501)
3-1 Procedure to Create the Slave and
Unit Configurations
This section provides the procedures for the Slave and Unit Configurations.
The shaded steps in the overall procedure that is given below are for the Slave and Unit Configurations.
Refer to 1-3 Overall Operating Procedure for the NJ-series Controller for details.
Step 1. Software Design
Step 1-1 Designing I/O and Processing
Step 1-2 Designing Tasks
Step 1-3 Designing Programs
Step 2. Software Setups and Programming
Step 2-1 Slave and Unit Configurations
Step 2-2 Controller Setup
Step 2-3 Programming
Step 2-4 Offline Debugging
Step 3. Mounting and Setting Hardware
Step 4. Wiring
Step 5. Checking Operation and Starting Operation on the
Actual System
To Next Page
Loading...
Need help?
General
