Troubleshooting
42
3
âť–
âť–âť–
âť– Duplex (Type 3 only)
When Memory Is Full
Problem Causes Solutions
Order of copies is not cor-
rect.
You set originals in the in-
correct order.
When setting a stack of originals in
the ADF or ARDF, the last page
should be on the bottom.
If you set an original on the expo-
sure glass, start with the first page
to be copied.
In Duplex Margin mode,
parts of the original image
are not copied.
The margin is too wide. Set a narrower margin with the user
tools. See “Duplex Margin” in p.55
“Duplex Margin”.
When using Duplex, copy
is made Top to Top even
though Top to Bottom is se-
lected.
You placed the originals in
the wrong orientation.
Place the originals in the correct ori-
entation. See p.18 “Original Orien-
tation” .
Messages Causes Solutions
Memory is full. [Print] scanned
orig., [Clear] to cancel/clear
memory.
[Clear][Print]
Note
âť’ Copying will stop and this message will be
displayed when the memory is full.
The scanned original
exceeds the number
of pages that can be
stored in memory.
Press [Print] to copy
scanned originals
and cancel the scan-
ning data. Press
[Clear] to cancel the
scanning data and
not copy.
Reset * orig., then press
[Resume] to scan and copy the re-
maining originals.
[Stop] [Resume]
The machine checks
if the remaining orig-
inals should be cop-
ied, after the scanned
original has been
printed.
To continue copying,
remove all copies,
and then press
[Resume]. To stop
copying, press [Stop].
KirC2_GBcopyF_FM.book Page 42 Tuesday, August 26, 2003 5:42 PM
To Next Page
Loading...
Need help?
General
