Other Transmission Features
28
3
Manual Dial
The external telephone is required.
Pick up the handset of the external
telephone and dial. When the line is
connected and you hear a high-
pitched tone, press the {
{{
{Start}
}}
} key to
send your fax message. If, on the oth-
er hand, you hear a voice at the other
end, continue conversation as nor-
mal.
A
AA
A
Place the original, and then select
the scan settings you require.
Reference
p.11 “Placing Originals”, Fac-
simile Reference <Basic Features>
p.25 “Scan Settings”, Facsimile
Reference <Basic Features>
B
BB
B
Pick up the external telephone.
You will hear a tone.
C
CC
C
Dial.
The machine immediately dials the
destination.
Note
âť’ If you make a mistake, replace
the external telephone, and then
try again from step
B
.
D
DD
D
When the line is connected and
you hear a high-pitched tone,
press the {
{{
{Start}
}}
} key to send your
fax message.
The transmission starts.
Note
âť’ If you hear a voice, tell the re-
ceiver that you want to send
them a fax message (ask them to
switch to facsimile mode).
E
EE
E
Replace the handset of the exter-
nal telephone.
After transmission, the standby
display appears.
Note
âť’ If you want to cancel a transmis-
sion, press the {
{{
{Clear/Stop}
}}
} key,
and then remove the originals.
Kir-C2-AEcombine_F_FM.book Page 28 Monday, September 29, 2003 11:39 AM
To Next Page
Loading...
Need help?
General
