Solving Operation Problems
102
8
Turning Off the Main Power/In Case of a
Power Failure
CAUTION:
Even if the main power switch is
turned off, the contents of the ma-
chine memory (for example, pro-
grammed numbers) will not be lost.
However, if power is lost for about
one hour because the main power
switch is turned off, there is a power
cut, or the power cable is removed,
contents of the Fax memory will be
lost. Lost items will include any fax
messages stored in memory using
Memory Transmission/Reception,
Memory Lock, or Substitute Recep-
tion.
If a file has been deleted from memo-
ry, a Power Failure Report is auto-
matically printed as soon as the
power is restored. This report can be
used to identify lost files. If a memory
stored for Memory Transmission was
lost, resend it. If a message received
by Memory Reception or Substitute
Reception was lost, ask the sender to
resend it.
Important
âť’ Do not turn off the main power
switch while the power indicator is
lit or blinking. If you do, the hard
disk and memory may be dam-
aged and failure could result.
âť’ Turn off the main power switch be-
fore pulling out the plug. If you
pull out the plug with the switch
on, the hard disk and memory may
be damaged and failure could re-
sult.
âť’ Make sure that 100% is shown on
the display before you unplug the
machine. If a lower value is shown,
some data is currently present in
memory.
âť’ Right after a power failure, the in-
ternal battery needs to be suffi-
ciently recharged to guard against
future data loss. Keep the machine
plugged in and the main power
switch on for about one week after
the power loss.
-
--
-RDS (Remote Diagnostic
System)
If your machine has a problem, a
service representative can perform
various settings over the telephone
line from the service station.
• When you disconnect the power
plug from the wall outlet, always
pull the plug (not the cable).
Kir-C2-AEcombine_F_FM.book Page 102 Monday, September 29, 2003 11:39 AM
To Next Page
Loading...
Need help?
General
