More Transmission Functions
31
3
More Transmission Functions
If Memory Runs Out While
Storing an Original
If memory runs out while storing or
sending an original (free space reach-
es 0%), one of the following messages
appears. Press [Exit] to transmit
stored pages only.
• During Memory Transmission:
"
Memory is full. Scanning
will be stopped and only
scanned page(s)
will be
stored.
"
• During Parallel Memory Trans-
mission:
"
Memory is full. Cannot scan
more. Transmission will be
stopped.
"
Note
âť’ In default, scanned pages are sent.
To change the settings to delete
scanned pages, contact your serv-
ice representative.
Parallel Memory Transmission
This function dials while the original
is being scanned. Standard Memory
Transmission stores the original in
memory, then dials the destination.
Parallel Memory Transmission al-
lows you to quickly determine
whether a connection was made. In
addition, this function scans the orig-
inal faster than Immediate Transmis-
sion. This is useful when you are in a
hurry and need to use the original for
another purpose.
Limitation
âť’ Standard Memory Transmission is
used instead of Parallel Memory
Transmission in the following cas-
es:
• When the line is busy and could
not be connected to
• With Send Later
• When you store an original for
Memory Transmission while
another communication is in
progress
• When two or more destinations
are specified
• When the first page of an origi-
nal is placed on the exposure
glass
Note
âť’ You can turn this function on or off
with the User Parameters. See p.80
“User Parameters” (switch 07, bit
2).
âť’ Standard Memory Transmission
may be used instead of Parallel
Memory Transmission if there is
not enough free memory left.
âť’ If you use this function, the Memo-
ry Storage Report will not be print-
ed.
âť’ If the {
{{
{Clear/Stop}
}}
} key is pressed,
an original will jam or memory
will run out during Parallel Mem-
ory Transmission stops. The Trans-
mission Result Report is printed
and files are deleted.
âť’ When Parallel Memory Transmis-
sion is used, the total number of
originals in “Fax Header Print” is
not automatically printed.
Kir-C2-AEcombine_F_FM.book Page 31 Monday, September 29, 2003 11:39 AM
To Next Page
Loading...
Need help?
General
