MFP Options
SM 2-121 D062/D063/D065/D066
Installation
2. Make sure that the following settings are not at the factory default settings:
Supervisor login password
Administrator login name
Administrator login password
These settings must be set up by the customer before the Data Overwrite
Security unit can be installed.
3. Confirm that "Admin. Authentication" is on:
[User Tools]> "System Settings"> "Administrator Tools"> "Administrator Authentication
Management"> "Admin. Authentication"> "On"
If this setting is "Off", tell the customer that this setting must be "On" before you can do
the installation procedure.
4. Confirm that "Administrator Tools" is selected and enabled:
[User Tools]> "System Settings"> "Administrator Tools"> "Administrator Authentication
Management"> "Available Settings
"Available Settings" is not displayed until Step 2 is done.
If this setting is not selected, tell the customer that this setting must be selected before
you can do the installation procedure.
Seal Check and Removal
Turn off the main power switch and disconnect the power supply cord.
1. Check the two box seals [A] on the corners of the box.
Make sure that the seals are attached at both corners.
The surfaces of the tapes must be blank. If you see "VOID" on the tapes, do not
Rev. 08/03/2009
To Next Page
Loading...
Need help?
General
